A
A.
Safety Installation Instructions
A. RTC Battery Warning
Subjective devices can only utilize the Lithium Carbon-mono-fluoride (BR) Coin Cells battery-BR2032, rated 3
V, 195 mAh, manufactured by RAYOVAC Corp.
Caution:
1. Batteries must only be changed in an area known to be non-hazardous.
2. Batteries must be installed with the positive (+) side facing as upper to avoid risk of shorting battery, fire or
explosion.
B. Fuse Warning
CAUTION: For continued protection against fire, replace only with same type and rating of fuse.
C. Rackmount Warning
The following or similar rackmount instructions are included with the installation instructions:
(1) Elevated Operating Ambient: If installed in a closed or multi-unit rack assembly, the operating ambient
temperature of the rack environment may be greater than the room ambient temperature. Therefore,
consideration should be given to installing the equipment in an environment compatible with the maximum
ambient temperature (Tma) specified by the manufacturer.
(2) Reduced Air Flow: Installation of the equipment in a rack should be such that the air flow required for
safe operation is not obstructed.
(3) Mechanical Loading: Mounting of the equipment in the rack should not create hazards that result from
uneven mechanical loading.
(4) Circuit Overloading: Consideration should be given to the connection of the equipment to the power
supply and the effect that overloading of the circuits might have on overcurrent protections or supply wiring.
Appropriate consideration of equipment nameplate ratings must be noted when evaluating this concern.
(5) Reliable Grounding: Reliable grounding of rack-mounted equipment should be maintained. Particular
attention must be given to indirect power connections that do not directly link to the branch circuit (e.g., over
power strips).
D. High Temperature Warning
(1) This equipment is intended to be used in a Restricted Access location like a locked computer room.
Access to this equipment should only be granted to AUTHORIZED SERVICE PERSONNEL or to users who have
been instructed about the the potential heat hazard posed by the metal chassis. This computer can become so
hot that after a long period of operations users and service personnel must take special care to wear protective
clothing before touching it. Only AUTHORIZED PROFESSIONALS should be allowed direct access to an
operating device.
