Movacolor MC-BALANCE, Руководство пользователя

Страница: 27 / 49

MC-Balance manual 24
7.7 Production
The rotation direction of the dosing at the front view must be to the right
Production (Motor On/Off)
Press the start button to start dosing, the question appears: Fill cylinder? YES/NO.
YES means that the dosing cylinder will be filled before production.
The start LED blinks when the unit is waiting for an input signal.
The unit is dosing if the Start LED lights continuously.
When the unit is started the actual production data will be shown.
Press the stop button to stop production.
Please notice that it is possible that the first dosing(s) are not sufficient, because of the cylinder filling with material.
It takes some time to stabilize.
.
Test function
With the test function the unit will dose material with the set dosing time and set / calculated speed.
In Extrusion mode the unit will dose 30 seconds.
Do a test as follows:
•
Go to PRODUCTION <menu>
•
Fill in the production settings
•
Use the arrow buttons to go to Test
•
Select YES and confirm .
•
The unit will run with the set parameters.
It is possible to stop the test with the stop button.
START
MENU
PRODUCTION
Regulation mode :
Auto/Manual
Save data : NO/YES
PRODUCTION SETTINGS
Ref Curve: MOVA
Prod Job :
xxxxxxxx
Material : xxxxxxxx
Color % : x.xxx %
Shot wth.: xxxx.x gr
Dos.time : xx.x s
Save Job : YES/NO
Test : YES/NO
STATUS
Set : 1,800 %
CALIBRATING/CALIBRATED
MIN or SHOTS
PRODUCTION DATA
Col.set. : x.xxx gr/s
Col.act. : x.xxx gr/s
Hopper : xxxx gr ><
Time : x.x sec
Speed : xxx.x rpm
Status : Dosing
MENU
MENU
4 levels of production screens:
The unit will switch automatically to the STATUS screen.
This screen is not available in
OPERATOR use level.
[For more information see chapter 7.8]
In INJ mode the remaining nr. of shots will be shown
In EXT mode the remaining production minutes will be shown
Calculated with the actual hopper weight and hopper empty weight