Movacolor MC-BALANCE, Руководство пользователя

Страница: 14 / 49

MC-Balance manual 11
APPENDIX A SHOWS THE PRINT VIEW WHICH WILL BE EXPLAINED BELOW
1) PROCESSOR BOARD
The processor board is the heart of the controller.
This board must be fixed securely on the mainboard.
There’s also a label on it with the Mac-address. This is the ID of the networkcard.
This address can also be seen in the startup screen.
2) EXTERNAL TERMINAL CONNECTION
This connector will be used when using an external terminal (Shielded cable max. 10 meter)
3) CONNECTION TO PC OR NETWORK
This connection (Ethernet) will be used when using a PC or network.
Max. length of the UTP network cable, type RJ45 (Cat. 5) is 100 meter between 2
network points.
4) INPUTS
Start input
The MC-Balance needs an input signal from the production machine in order to operate.
Three different input signals can be used to control the MC-Balance:
•
Potential free start input.
•
Potential (24 Vdc) start input
•
Tacho (0-30 Vdc) start input
5) MOTOR
The MC-Balance can control 2 motor types:
•
LT (low torque) standard motor for normal dosing
•
HT (high torque) motor for high output dosing
(See chapter 5 for more details and wiring diagram for electrical connections, appendix C)
6) OUTPUTS
The MC-Balance has following outputs available:
•
[clamp 24-25] Valve output for hopper loader, (Solid state 24VDC/0.5 A)
•
[clamp 22-23] Warning output (Solid state 24VDC/0.5 A)
•
[clamp 26-27] Potential free relay (normally open) output for Alarm (max. 230Vac/30Vdc, 5A)
•
[clamp 28-29] Potential free relay (normally open) output for Running contact
(max. 230Vac/30Vdc, 5A). This contact will be used to show that the motor is running.
The maximum total output power may be 12 Watt (Valve alarm output together max. 0,5A)
(See wiring diagram appendix C for electrical connections)
7) POWER SUPPLY
The MC-Balance will operate with a voltage from 80 VAC to 260 VAC, 50 and 60 Hz
by integrated automatic voltage selector.
(See wiring diagram appendix C for electrical connections)