motortronics CSD Series, Руководство по эксплуатации и обслуживанию

Страница: 26 / 76

CSD Series Variable Frequency AC Drive
MOTORTRONICS
- 22 -
5.1 Introduction
This chapter explains the command keys, LED Display, flashing lights
and shows how easy the
CSD Series is to program.
Command Keys
1. RUN/STOP - With keypad control, this starts and stops the motor.
2. FWD/REV - With keypad control, this controls the direction of
motor shaft rotation.
3. FREQ. SET - Potentiometer used to control motor speed. (See
section 5.3, Fn11)
4. DSP/FUN - Used to show either operating display or functions.
5. UP/DOWN - Changes the numeric display to higher or lower
setting.
6. SHIFT LEFT/RESET - This is a digit selection key. Using shift/
left arrow moves flashing LED to the left for faster numeric pa-
rameter change. Use reset if the drive has tripped. Pushing this
key will reset the faults if the fault condition has been cleared.
7. READ/ENTER - Allows you to read the function data or to enter
new function settings.
Easy Programming
The CSD Series has two basic programming
loops:
Operation Loop - changes frequency to in-
crease/decrease motor speed.
Programming Loop - changes function set-
tings.
LEDs
The chart above describes the meaning of
illuminated LEDs
(For location, see Figure 5 - 1).
Table 5 A - LED Description
Figure 5 - 2
Programming Loops
* The numerical display will
blink in stop mode
Figure 5 - 1
Keypad Display
Chapter 5 - Digital Operator Control/Keypad Operation
SEQ FRQ FWD REV
Hz
RPM
FUN
VOLT
AMP
RUN
STOP
DSP
FUN
FWD
REV
RESET
READ
ENTER
FREQ. SET
1.
2.
3.
4.
6.
7.
5.
8 8 8 8
*
POWER ON
Displays Voltage
Displays Frequency
Programming
Loop
Operation
Loop
Change
Function?
Change
Frequency?
DSP
FUN
RESET
Press this
key to
display
function number
(FXXX = #) Press any
of these
keys for
desired
frequency
setting
RESET
Press any
of these
keys to
reach
function
to be
changed
READ
ENTER
Press this
key to save
new frequency
setting
READ
ENTER
Press this
key to
read existing
function
RESET
Press any
of these
keys to
enter new
setting
READ
ENTER
Press this
key to
enter new
function setting
DSP
FUN
Press this
key to
return to
frequency display
or skip this key to
continue changing
functions
DSP
FUN
Note: This
key allows
you to
switch from one
loop to another