Motortech EasyNOx, Руководство по эксплуатации

Страница: 11 / 142

2 Safety Instructions
Rev. 06/2021 11
– Avoid all activities that can impair the function of the equipment.
– Operate the equipment only while it is in proper condition.
– Investigate all changes detected while operating the gas engine or ignition system.
– Ensure compliance with all laws, directives, and regulations applicable to the operation of
your system, including such not expressly stated herein.
– If the system is not entirely tight and sealed, gas may escape and result in explosion hazard.
The inhalation of gas can also lead to death or severe health damages. Therefore, upon com-
pletion of all assembly works, always check the system's tightness.
– Always ensure adequate ventilation of the engine compartment.
– Ensure a safe position at the gas engine.
– There is a risk of burning on hot surfaces. Allow the gas engine to cool down before starting
any work.
– Personal protective equipment (PPE), e.g. safety shoes and gloves, must be worn during all
work on the gas engine.
– Noise from the system can cause permanent or temporary damage to your hearing. Wear
suitable hearing protection at the system.
– Your behavior can reduce possible residual risks to a minimum. Observe responsible han-
dling of the gas engine and the gas-carrying system.
2.2 Electrostatic Discharge Hazards
Electronic equipment is sensitive to static electricity. To protect these components from damage
caused by static electricity, special precautions must be taken to minimize or prevent electro-
static discharge.
Observe these safety precautions while you work with the equipment or in its vicinity.
– Before performing maintenance or repair work, ensure that the static electricity inherent to
your body is discharged.
– Do not wear clothing made from synthetic materials to prevent static electricity from build-
ing up. Your clothing should therefore be made of cotton or cotton mix materials.
– Keep plastics such as vinyl and Styrofoam materials as far away from the equipment as pos-
sible.
– Do not remove the circuit boards from the housing of the device.