REPE
ATER CLONING
50
User Guide
Note:
After cloning is completed, the RDX radio
sounds either a “pass” tone (cloning was
successful) or a “fail” tone (cloning process
has failed). The “pass” tone sounds like a
good key “chirp” whereas the “fail” tone
sounds similar to a “bonk” tone. If the RDX
radio is a display model, it either shows
“Pass” or “Fail” on the display (a tone is
heard within 5 seconds).
6.
Once you have completed the cloning
process, turn the RDX radio OFF and ON to
exit ‘clone’ mode.
7.
Turn the repeater OFF and ON to exit “clone”
mode.
- If the RDX channels contains
frequencies that are not
within the repeater TX or RX
frequency range: the
repeater does not work on
these channels.
- In the RDX radio, make sure
that in each one of the TX/
RX frequency pairs, the
bandwidth setting has
exactly the same value. For
example, if in Channel 7 the
TX bandwidth separation is
12.5 kHz, then the
corresponding RX
bandwidth separation in this
same channel 7 should be
also 12.5 kHz.
Important
2000018_B_PORS_en.book Page 50 Thursday, January 14, 2010 2:10 PM
