Motorola MVME2603-1121A, Инструкция по установке и эксплуатации

Страница: 33 / 210

Hardware Preparation and Installation
1-17
1
Serial Ports 1-4 DCE/DTE Configuration
Serial ports 1 through 4 are configurable as modems (DCE) for
connection to terminals, or as terminals (DTE) for connection to
modems. The MVME712M is shipped with the serial ports
configured for DTE operation. Serial port DCE/DTE configuration
is accomplished by positioning jumpers on one of two headers per
port. The following table lists the serial ports with their
corresponding jumper headers.
The next six figures illustrate the MVME2603/2604 base board and
MVME712M transition module with the interconnections and
jumper settings for DCE/DTE configuration on each serial port.
Serial Port 4 Clock Configuration
Port 4 can be configured via J15 ( Figure 1-4 ) to use the TrxC4 and
RtxC4 signal lines. Part of the configuration is done with headers
J16, J17, and J20 on the MVME2603/2604 (Figures 1-9 and 1-10).
Figure 1-4. J15 Clock Line Configuration
Table 1-3. MVME712M Port/Jumper Correspondence
Serial Port
Board
Connector
Panel Connector
Jumper
Header
Port 1 J7 SERIAL PORT 1/ CONSOLE J1/J11
Port 2 J8 SERIAL PORT 2/ TTY J16/J17
Port 3 J9 SERIAL PORT 3 J13/J14
Port 4 J10 SERIAL PORT 4 J18/J19
TRXC4 TO PORT 4 PIN 15
TRXC4 TO PORT 4 PIN 17
TRXC4 TO PORT 4 PIN 24
RTXC4 TO PORT 4 PIN 24
RTXC4 TO PORT 4 PIN 17
RTXC4 TO PORT 4 PIN 15
J15
3 1 9 5 7 11