Motorola Horizonmacro outdoor, Руководство по установке и настройке, Страница: 149 / 212

GSM-204-423 Installing batteries in the auxiliary equipment housing
31st Oct 01
Installation & Configuration: Horizon macro outdoor
68P02902W03-A
CONTROLLED INTRODUCTION
Inst. 5–7
Installing
batteries
NOTE Battery trays, retaining plates and leads are supplied with
the auxiliary equipment housing (AEH).
Batteries are not supplied with the AEH. They must be
obtained separately by the customer.
Motorola recommend the use of Yuasa or Hawker 6 V
batteries (kit number SVPN1216 contains eight batteries
).
WARNING The batteries are capable of supplying high short circuit
currents and as such provides a high energy hazard.
To install batteries in the auxiliary equipment housing:
1. Ensure that batteries to be installed are fully charged and load tested in
accordance with battery manufacturers handbook.
2. Remove the front panel from the housing by undoing the six retaining
screws and disconnecting the cable to the fan assembly (contained within
the front panel).
3. Disconnect the heater mat power connectors at each tray and remove the
upper three battery trays in the auxiliary equipment housing (if not already
removed).
4. Install the four batteries onto the bottom tray in the cabinet so that the
positive and negative terminals match the arrangement shown in
Figure 5-4.
5. Connect the leads to the terminals as shown in Figure 5-5 and then fit the
front retaining plate.
6. Install the battery tray for row 2 in the auxiliary equipment housing,
reconnecting the heater mat power connector at the tray.
7. Install the four batteries onto the row 2 tray so that the positive and
negative terminals match the arrangement shown in Figure 5-6.
8. Connect the leads from the batteries in row 1 to the terminals of the
batteries in row 2 as shown in Figure 5-7. Fit the front retaining plate.
9. Connect the black cable from the power distribution box on the lid to the
positive terminal on the left rear battery in row 2.
10. Connect the blue cable from the power distribution box on the lid to the
negative terminal on the right rear battery in row 2.
Repeat steps 3 to 9 of the above procedure if a second bank of batteries is to
be installed in the housing above the first bank.