Motorola BSR 2000, Руководство по настройке и управлению

Страница: 509 / 650

Release 1.0 Configuring OSPF
526360-001-00 Rev. B MGBI 11-19
where:
1-3600
is the OSPF transmission delay in seconds.
4. Use the ip ospf priority command in Interface Configuration mode to set priority
of this router interface to determine the OSPF designated router on the OSPF
network:
MOT (config-if)#
ip ospf priority <
1-255
>
where:
1-255
is the priority for this router interface.
5. Use the ip ospf hello-interval command in Interface Configuration mode to
specify the length of time between the hello packets that the software sends on an
OSPF interface:
MOT
(config-if)#
ip ospf hello-interval <
1-65535
>
6. Use the ip ospf dead-interval command in Interface Configuration mode to set
the number of seconds that hello packets must be absent before the device
neighbors declare the OSPF router
down
:
MOT
(config-if)#
ip ospf dead-interval <
1-65535
>
where:
1-65535
is the number of seconds before the OSPF router is considered
down. The default is 40 seconds.
7. Use the ip ospf authentication-key command in Interface Configuration mode to
assign a password for neighboring OSPF routers to use on a network segment that
uses OSPF simple password authentication:
MOT (config-if)#
ip ospf authentication-key <
WORD
>
where:
WORD
is the unencrypted (clear text) with 1 to 8 characters.
8. Use the ip ospf message-digest-key command in Interface Configuration mode
to enable OSPF MD5 authentication:
MOT
(config-if)#
ip ospf message-digest-key {<
1-255
> md5 <
WORD
>}
where:
1-255
is the MD5 secret Key ID number.