MotorGuide TOUR 109, Руководство по эксплуатации, техническому обслуживанию, установке и гарантии

Страница: 73 / 76

Trolling Motor Performance
Symptom Possible Cause Resolution
Loss of power
Weak battery
Refer to
Wiring and Battery
Information
.
Loose or corroded battery
connections
Propeller is loose,
damaged, or off‑balance Refer to
Maintenance
.
Wiring or electrical
connection faulty
Wire gauge from the battery
to the trolling motor is
insufficient. Six‑gauge wire
(13 mm²) is recommended.
Weeds, fishing line, or
debris wrapped around
propeller
Remove weeds, fishing line,
or debris from propeller.
Excessive noise,
vibration
Motor shaft is bent
Refer to
Warranty
Information
.
Propeller is loose,
damaged, or off‑balance Refer to
Maintenance
.
Motor failure (all
speeds)
Weak battery
Refer to
Wiring and Battery
Information
.
Loose or corroded battery
connections
Electrical
Check the connector for a
loose or damaged
connection. Refer to
Wiring
and Battery Information
.
Fuse or circuit breaker is
open
Locate and correct the cause
of the overload. Then replace
the fuse or reset the circuit
breaker.
Motor failure (one
or more speeds)
Propeller is loose,
damaged, or off‑balance Refer to
Maintenance
.
Wiring or electrical
connection faulty.
Refer to
Warranty
Information
.
Difficulty removing
propeller
Bent propeller pin
Hold one blade and lightly
tap the opposite blade with a
rubber mallet.
Use a putty knife on both
sides of the propeller to apply
equal pressure.
Bent armature shaft Refer to service center.
TROUBLESHOOTING
eng
67