MotorGuide TOUR 109, Руководство по эксплуатации, техническому обслуживанию, установке и гарантии

Страница: 60 / 76

To switch back to heading lock—course mode, press and hold the
manual
mode
button, then press the
2, 1, 1
buttons in sequence.
Adjusting Motor Speed
If a heading lock mode is selected from manual mode, the trolling motor will run
at the last selected speed. The motor speed can be adjusted by pressing the
increase speed (+)
button or
decrease speed (–)
button on the remote or by
rotating the speed knob on the foot pedal
counterclockwise
to increase the
speed or
clockwise
to decrease the speed. The trolling motor will emit two
beeps when the user tries to exceed the available motor speed limits.
Cruise control can be used while in either heading lock mode. Refer to
Using
Cruise Control
.
Adjusting the Heading
While in a heading lock mode, the heading can be adjusted by pressing the
left
turn
or
right turn
buttons on the handheld remote or by holding the momentary
button down on the foot pedal while steering the foot pedal toe down on the
foot pedal
toe down
to steer right or
heel down
to steer left. The trolling motor
will resume heading lock—course mode navigation based on the new trolling
motor heading.
Changing the Heading Lock Mode
Heading lock—course mode is the default heading lock mode. To switch to
heading lock—compass mode, press and hold the
manual mode
button, then
press the
2, 1, 2
buttons in sequence. To switch back to heading lock—course
mode, press and hold the
manual mode
button, then press the
2, 1, 1
buttons
in sequence.
IMPORTANT: The Pinpoint GPS system will remember which heading lock
mode was last used, and the next time the heading lock button is pressed, the
trolling motor will operate that mode.
OPERATING IN ROUTE MODE
Route mode has the ability to store and recall user‑defined routes. These
routes can be recorded and recalled by the user from any operating mode.
TROLLING MOTOR INSTALLATION AND OPERATION
54
eng