Morita DENTA PORT ZX, Руководство по эксплуатации

Страница: 21 / 36

Page17
Operation 2018-03-22
3.
Take out the old batteries and replace them with new ones.
Make sure the plus and minus poles are correctly lined up.
(1) Insert the batteries by first pressing center of the minus
end against its spring contact and then sliding the plus end
down into place.
(2) Make sure the contacts are not bent or damaged.

Do not reverse the plus and
minus poles.

Never allow the spring contact
to push against the edge of the
battery. This could damage
the outer cover causing a short
or a leakage of battery liquid.
4. Line up the projections on the cover with the notches in the
module. Fit the cover onto the module and slide it down
into place.
5. Slide the cover all the way down until it is snugly seated on
the module.

If the catch on the bottom is not back in its original place
after attachment, push it in the direction shown by the
arrow in the illustration.

After installation, give the cover a light tug to make sure it
is securely attached.

Always use alkaline AA batteries.

Never use rechargeable nickel-hydrogen or nickel-cadmium batteries.

Replace all three batteries at the same time.

Make sure that the plus and minus poles are correctly aligned.

Never use batteries that are leaky, deformed, discolored or otherwise abnormal.

Dispose of old batteries according to local codes and regulations.

In case of battery leakage, carefully dry the battery terminals and remove all of the leaked liquid.
Replace the battery with a new one.
* Overheating could result if the above conditions are not adhered to.
* The three AA alkali dry cells used for this equipment will last for about 100 hours of use. (This equals 6 to
12 months at normal rates of usage.)
Cover
Canal Measurement
Module
4
5
Notches Tabs
Canal Measurement
Module
Cover
BAD