48
MB 200
rev.0.1UL ID1460
7.1.3 MEASURING ThE BOOK
The measuring of the book to be bound is necessary for an automatic set the opening of the vise
and of the glue unit.
01
Insert the book block to be measured. Automatically the
probe will clamp the book in order to take the measurement.
When the value read by the linear encoder will result stable,
the measurement will be transferred to the machine.
02
After the measurement remove the book block and place
the probe in the fully open position.
03
If you wish to perform continuous measurements, such
as inserting or removing parts of the book block, once the
correct measure is found just press the left button of the
dual control to acquire the measurement.
Note: The measurement table does not work as long as the rear hit of the cover is moving. If
it were necessary to reset the measuring table have the probe close against the vertical wall
of the machine (minimal measure) then place the probe in the fully open position.
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
