25
MB 200
rev.0.1UL ID01460
By pressing on the hand (
3f
) you access the page of the manual movements of the extruder.
3g.
Current shares (green) and settable (blue);
3h.
Glue leak button icon.
• Hold down the button for less than one second to open and close the valve of the glue.
• By holding down the button for less than two seconds but more than one:
-
I open and close the glue valve;
-
I put into pressure the glue tank. This pressure is maintained for Max 10 sec.
• By holding down the button for more than two seconds:
-
I open and close the glue valve;
-
I put into pressure the glue tank;
-
I open the valve of the glue until the release of the button. This command causes the
glue to leak from the coating head;
3i.
Button icon with blue arrow: controls the opening of the cleaner until the button is released;
3l.
Glue discharge button icon;
3m. Previous page icon;
3n.
Corrective value for the coating head (- 0.5mm ─ 1mm);
3o.
Set automatic glue or manual mode;
3p.
The value in green is that of the pressure within the pre-melting unit, the one in blue is the
one that the tank will reach by holding the button 3h.
The extruder pre-set can run even from this page by selecting the icon
3.0
999999
50
50
999
99
99
10
130
120
10 FREE
1-30
Note: All movements can be performed only when the machine is at temperature.
3h
3g
3n
3i
3l
3m
3o
3p
