Operator Manual
DigiBook 150
57
Rev. 1.00-C
Preparation of the machine to manufacture a book.
CONTROLS TO PERFORM BEFORE STARTING THE JOB
Before to use the Perfect Binder perform the following controls:
The operator must have read and understood this manual, including the important
information concerning the SAFETY.
Make sure you have appropriate clothing to work and, if necessary, also safety
clothing.
Ensure that the Master Book is properly powered and connected to ground (PE)
Ensure that the pneumatic system of the Master Book is properly fed and if the
main switch oh the factory is open.
Verify that the chips aspirator is connected to the Master Book and its power switch
is in position 1 = ON.
Check that in the tank there is a minimal amount of glue to allow manufacturing
several books, otherwise insert a new cartridge of glue inside the tank.
Glue collection tank flushed.
Ensure that the Master Book is clean and without books or covers, especially:
Clamp, Silent Plate, Milling Station, PUR head, Press.
Check that the temperature settings are correct for the used glue and that have been
achieved the correct values to work.
Refer to the technical sheets of the glue/cleaner manufacturer.
Verify that the values of temperatures have reached their work values.
Both temperature indicators must be lit.
If necessary, remove the layer of Blue-Cleaner from the PUR head.
MyBinding.com
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
