TIY
The Interface Solution Experts 17
Programmable Isolated
Thermocouple Transmitter
Installation
Installing the TIY consists of physically mounting the
unit and completing the electrical connections. The
following sections describe these tasks.
Mounting the TIY
The TIY is available in an HP- or DIN-style housing.
Physical mounting requirements differ for each
housing style.
The HP Housing.
Figure 4 is an outline dimensional
drawing of the HP-style unit with the FL housing
option. The spring clips on standard HP-style units
(not shown) have no dimensional significance.
The spring clips on HP-style units hold the
unit in place when mounted in explosion-proof
enclosures. The spring clips are squeezed inward
to allow for positioning of the unit in the base of the
explosion-proof enclosure. When released, they
recoil to an extended position slightly over the outer
edge of the unit, providing adequate pressure to hold
the unit in the enclosure.
The DIN-style Housing.
Figure 5 is an outline
d i m e n s i o n a l d raw i n g o f t h e D I N - s t y l e T I Y.
DIN-style units mount directly onto standard G-type
(DIN EN50035) and Top Hat (DIN EN50022) rails.
This packaging is ideal for high-density mounting of
DIN-style packages on one common DIN rail.
Figure 4
. Dimensions of the TIY in HP Housing
SAVE
CANCEL
ZERO
SPAN
75mm
(2.97 in)
32mm
(1.25 in)
83mm
(3.25 in)
73mm
(2.86 in)
61mm
(2.40 in)
TIY
61mm
(2.42 in)
60mm
(2.35 in)
+PS –PS +IN –IN
