2
The Interface Solution Experts
ENTER
PASS
Enter the password
code to enable
settings changes.
Configure Zero & Full Scale:
Set the values to be displayed
at zero and full scale.
Trim Output:
Connect the SPT into a
calibration setup as shown
in the manual and trim the
analog output.
Configure Sensor:
Choose input type.
Password:
View or change password.
Input Zero and Full Scale:
Set the zero and full scale
values. (bench ranging)
Exit Configuration Menu:
Return to process display.
Configure Options:
Set engineering units, linearization
mode, and upscale/downscale drive.
Security Jumper
installed in OFF position.
Security Jumper
installed in ON position.
VIEW current settings
Front Panel
Push Buttons
Inactive during operation.
Inactive during operation.
SELECT
Use or push buttons to scroll
through menus and sub-menus.
Use SELECT push button to access
menu and/or make a choice.
VIEW
CONF
SENS
CONF
OPTS
CONF
Z/FS
INPT
Z/FS
TRIM
OUT
CONF
EXIT
CONF
ALRM
Configure Alarm:
Set trip point, deadband,
high\low trip, delay, and
latching\non-latching.
PASS
WORD
SPA TPRG Quickstart Guide
Use the front push-buttons to quickly and
easily setup the SPA for your application.
After programming your alarm using the
diagram below, install the unit into your ap-
plication using the connection diagram and
terminal designation table on pages 28 and
29 of this manual.
