Moog Tritech Super SeaKing 700 V7 Series, Руководство по эксплуатации продукта

Страница: 10 / 35

4 0688-SOM-00001, Rev: 02 © Tritech International Ltd.
2. Installations
2.1 Hardware Installation
Mount the Seaking 700 using 3mm insulating rubber, and jubilee clamps to firmly secure
to the vehicle.
For accurate pressure measurement, the Seaking 700 Bathymetric sensor can be orientated
in a port up or port down configuration with calibrated offsets provided by the factory.
It’s recommended, during installation, that the bathy and altimeter be positioned so they
receive good water flow while avoiding prop-wash from thrusters.
It’s advisable that the conductivity sensor head should have a free radius of at least 10cm.
Objects within this must be electrically stable (either a fixed dielectric or conductor) and
have a fixed position relative to the sensor. Locate the sensor head away from items such
as motors, sense coils and cameras to ensure accurate readings.
Ensure the Seaking 700 is protected from the possibility of impact damage.
During Installation, be sure to safeguard against damage to the protective anodised
coating on the main housing. Any chips or scratches may lead to corrosion of the housing
which may impact the performance of the system.
Mate connectors/blanks ensuring the washers are in places and have been greased and
the securing screws have been tightened.
DO NOT OVER-TIGHTEN RETENTION SCREWS.
If using a Seacon connector, you are reminded that
the retention ring should be finger tight. Applying too
much pressure risks damaging the connector.
Check that the cables and connectors are not subjected to excessive strain and are not
kinked or bent excessively. The safe bend radius of the V7 cables is 100mm.
Caution
Non-metallic clamps are preferred when securing the
Bathy, however, if metallic clamps are to be used they
must be electrically insulated to protect the housing.
Avoid any clamping material that may
contain brass or bronze.