XT0016
6
Installation
RX 200
Operation w/ Backup Battery
RX 200
Operation with MAIN Power
F. Operation with Backup Battery:
1. Install the four supplied AA batteries to the battery holder.
CAUTION: Please note battery orientation while installing them.
Incorrect orientation may damage battery, cause fire hazard and
the fireplace may not function properly.
2. Follow the instructions on the "Proflame2 Operation and Maintenance
Manual- XG0677" to install batteries on the remote control.
3. Turn the gas supply ON.
4. Program the remote control to the control module (see "Proflame2
Operation and Maintenance Manual- XG0677").
5. Check the stepper motor for gas leaks and ensure no leak.
5. Turn the fireplace ON and modulate the flame using the remote
control and ensure proper operation (see "Proflame 2 Operation
and Maintenance Manual XG0677").
Blue Back lit LCD display
On/Off Key
Thermostat Key
Up/Down Arrow Key
Mode Key
Figure 24
Proflame Remote Control
G. Operation with MAIN Power:
1. Remove the four batteries from the battery holder
2. Plug the Control Module Power cord to PPO box. See
Figure 3
.
3. Turn the fireplace ON using the remote control and confirm
operation with main power ON.
Note:
You may re-install the backup batteries to the battery holder
at this point to ensure that fireplace is operational during power
outage. It is recommended to check and replace the backup batter-
ies at least once a year. More frequent battery replacement may be
required in case of extended operation on backup batteries.
