XT0016
2
General
This upgrade kit shall be installed by a qualified service agency in
accordance with the manufacturer's instructions and all applicable
codes and requirements of the authority having jurisdiction. If the
information in these instructions are not followed exactly, a fire,
explosion or production of carbon monoxide may result causing
property damage, personal injury or loss of life. The qualified service
agency is responsible for the proper installation of this kit. The
installation is not proper and complete until the operation of the
converted appliance is checked as specified in the manufacturer's
instructions supplied with this kit.
This upgrade kit contains the necessary components for field upgrade
of an approved Montigo fireplace from Proflame 2 basic control
system to Full Load with remote.
The installation of this unit must also conform with local codes or, in
the absence of local codes, with the American National Fuel Gas Code,
ANSI Z223.1, or the Canadian Installation Code, CAN / CGA B149.
WARNING
GENERAL INFORMATION
Note
Upon successful installation of
this upgrade kit, the following
features are available for the
user:
1. Thermostatic and smart
thermostatic control of the
fireplace
2. M a i n b u r n e r f l a m e
modulation (6 levels)
3. Choice of Standing or
Intermittent pilot (CPI switch
or jumper required)
4. Comfort fan speed modulation
(Remote Fan Kit RFK3002R or
RFK3004R required)
5. Battery backup for the main
burner during power outage
Before You Begin
Ensure that the power supply
has been turned off at the
breaker or fuse before beginning
the installation.
Shut off the gas supply at the
shut-off valve, and ensure that
the main burner and pilot light
have been turned off and the
fireplace has been cooled off
for at least two hours before
installation.
Tools Required
• T20 Torx bit
• Impact gun / Drill
• 1/4 " Nut driver bit
Contents
A. Disconnect Control Module and Harness: .........................................3
B. Stepper Motor Installation: ..................................................................3
C. Control Module Installation: ................................................................4
D. Main ON/OFF Switch Installation: .......................................................5
E. Battery Holder Installation: ..................................................................5
F. Operation with Backup Battery: ...........................................................6
G. Operation with MAIN Power: ...............................................................6
H. CPI / IPI Jumper Cable Installation ......................................................7
KIT #
Contents
RX200NG
RX300NG
Control Module, Remote Control, Stepper Motor-NG,
Manual Override switch with harness and bracket,
backup battery pack, Proflame 2 operations manual,
hardware and batteries.
RX200LP
RX300LP
Control Module, Remote Control, Stepper Motor-LP,
Manual Override switch with harness and bracket,
backup battery pack, Proflame 2 operations manual,
hardware and batteries.
Note:
You may remove the front cover (
See Figure 2
), or the
burner assembly to access the control module and wiring. If
removed, please ensure it is re-installed properly and all gas
connections are leak tested.
Remote Control
Control Module
Battery
Pack
Manual override
switch with harness
and bracket
Stepper
Motor-NG
or LP
Proflame 2
Operations Manual
Figure 1
Contents of Proflame 2 Upgrade Kit
Hardware and
batteries
Figure 2
Fireplace front cover
