XT0016
5
Installation
RX 200
ON/OFF Switch Installation
RX 200
Battery Holder Installation
D. Main ON/OFF Switch Installation:
1.Position the Main/off Switch bracket on the right leg of the firebox.
2. Using the two selftapping screws supplied attach the bracket.
3. Feed the switch and the wires through the slot in the bracket as
shown and install the switch to the bracket. See Figure 21.
4. Secure the wires to the floor of the fireplace using the supplied cable
tie and cable tie mounts.
5. Attach the "Main ON/OFF" sticker supplied to the switch bracket.
E. Battery Holder Installation:
1. Secure the battery holder to the fireplace floor using the supplied
velcro strips. See Figure 22.
Note: The velcro strips act as an electrical isolation, do not attach
the battery holder to any metal part without using the velcro strips,
or the control module will be damaged.
2. Connect the red and black wires from the battery holder to the red
and black wires from the valve harness. See Figure 23.
Figure 18
Attach switch bracket to front of fireplace
Figure 19
Attach switch bracket to front of fireplace
Figure 20
Attach switch to bracket.
Figure 21
Attach switch to bracket.
Figure 22
Battery holder
Figure 23
Battery holder wires
