XG0528 - 170223
18
Installation
Figure 5.17
Figure 5.21
Figure 5.24
Figure 5.25
Figure 5.22
Figure 5.18
Figure 5.19
Figure 5.23
Figure 5.20
7. Remove the twist tie and Zap Strap that is on the On / Off Switch
wire harness.
11. Place the Zip Strap
through the hole in the
Plastic Stick on Retainer
on the back of the Rear
Faceplate. Zip the wires
together in one tidy
package as shown.
11. Hooks are used to secure
the Front Faceplate at the
bottom left and right.
11. Trim installation
completed.
12. Place the master override
switch in the OFF position.
Until the remote is synced
to the control board, this
switch acts as a master.
If you apply gas and
power to the unit while
this switch is in the ON
position, it will initiate
lighting.
8. Slip the Split Plastic Grommet, found in the plastic bag attached
to the master override switch, around the Power Cable and then
press it into the provision on the right lower side of the Rear
Faceplate to secure the Power Cord.
9. Thread the On/Off Wire Harness through the gap between the
Control Board Mounting Bracket and the Rear Faceplate Panel.
13. At this stage it is easiest to install the batteries. See section on
battery installation and replacement.
14. The Front trim can now be installed. It has two fasteners at the
bottom which must be engaged in the bottom right and left of
the Front Faceplate. Magnets hold it at the top right and left.
10. Connect the Plug to the appropriate terminal on the Control
Panel.
