XG0528 - 170223
13
Installation
Figure 4.3
Converting the gas regulator on the valve
Figure 4.6
Figure 4.12
Figure 4.7
Figure 4.8
Figure 4.4
Figure 4.10
Figure 4.9
Figure 4.5
Figure 4.11
2. Swing the valve away from the unit in order to get access to the
front of the valve and regulator. Be careful not to damage gas
lines or wires.
5. Remove the top 2 screws
that hold the control
mounting bracket in place.
11. Plug the cable into the
control board.
6. Unplug the cable that runs
from the stepper motor
to the control board and
remove it from in between
the control board bracket
and the fireplace.
12. Reinstall the 2 screws
to secure the top of the
control board mounting
bracket. Using the zip
strap supplied, secure
the excess of wires neatly
within the control / valve
area. Re-install the 2
screws that keep the
valve body from swinging
out from the unit. When
swinging valve back in
use care to not pinch or
kink wires or pilot gas line.
Inspect pilot gas line for
leaks.
7. Place the Propane stepper
motor onto the valve
being extremely careful
that the orientation of the
regulator is correct.
3. Using a T20 Torx screw
driver, remove the 2
screws that attach the
stepper motor to the valve.
9. Attach the label provided
to the side of the valve
body.
8. Reinstall the 2 screws
supplied with the
conversion kit to fasten
the stepper motor to the
valve body.
4. Remove the screws,
stepper motor and rubber
diaphragm.
10. Run the cable from the
stepper motor in between
the control mounting
bracket and fireplace.
