Monterey Sport Cruiser 260SCR, Руководство пользователя

Страница: 80 / 212

Boat Features and Options
Cruiser
8-13
Engine Emergency Stop Switch
and Lanyard (260/280 Only)
The engine emergency stop switch controls the
engine ignition ON/OFF. This safety device shuts
the engine off immediately and prevents the boat
from becoming a runaway if the operator is
accidentally thrown from the seat or away from
the helm.
Whenever your boat’s engine is on, physically
secure one end of the emergency engine stop
switch lanyard to the emergency stop switch and
the other to the boat operator. If the operator is
thrown from the seat or moves too far from the
helm, the lanyard will disconnect from the switch,
activating the switch to turn off the engine.
• Never remove or modify the engine emergency
stop switch and/or lanyard.
• Always keep the lanyard free from obstructions
that could interfere with its operation.
• Always check the switch for proper operation.
With the engine running, pull the lanyard. If the
engine does not stop, have the switch repaired
before operating your boat further.
• Never operate your boat if the engine
emergency stop switch does not work.
WARNING! Removing the engine stop
switch and/or the lanyard can cause loss of
control. See Safety Precautions in the Safety
Section of this manual for more details.
Figure 8-8
Figure 8-20
Neutral Start Safety Switch
(Start-in-Gear Prevention)
The neutral start safety switch provides
start-in-gear prevention. The switch controls
power to the engine starter circuit of the ignition
switch. The engine gear shift control lever must
be in the NEUTRAL position to allow the ignition
switch to activate the engine starter. This safety
device will prevent the boat’s engine from starting
if the engine is in gear.
Navigation Lights Switch
The navigation lights switch controls power
ON/OFF to the boat’s navigation, running and
anchor lights. This switch is usually a
three-position switch, with OFF in the center.
When the switch is in the NAV position, the red
and green navigational, white stern and running
lights, and console gauge lights; are activated.
When the switch is in the ANC position, only the
white stern light is activated.
Never operate your boat between sunset and
sunrise using only the stern light. Use all
navigational lights when operating under way
between sunset and sunrise.
Bilge Pump Switch
The bilge pump switch controls power ON/OFF to
the bilge pump to remove excess water from the
bilge area of the boat. All models are equipped
with an automatic bilge pump, which will allow
water to be automatically pumped out when it
reaches a level that activates the float switch in
the bilge area.
Running the pump when the bilge is dry will
damage the pump. Do not allow the bilge pump to
operate after all the water has been cleared from
the bilge area; damage to the pump will occur if
the pump is allowed to operate without water.
If oil is spilled in the bilge, do not run the pump.
Keep the oil from spreading in the bilge and
properly dispose of the oil on shore.
KC-0110-A
SAFETY SWITCH
LANYARD
HOOK