Monterey Boats 378SE, Руководство пользователя

Страница: 96 / 210

96
MONTEREY
BOATS
Drainage Systems
The pumps can also be activated by flooding the
bilge with a garden hose until they activate.
The automatic float switch for the emergency
bilge pump is mounted above the normal operat-
ing range of the aft bilge pump automatic switch.
It activates an alarm if the bilge water level rises
above the normal operating range of the bilge
pump automatic switches. The alarm/emergency
pump switch is connected to the house battery
bank and is protected by the Emergency Pump
“push to reset” breaker in the battery switch
breaker panel. It remains activated when the
battery switches are in the OFF position and the
batteries are connected.
When the boat is out of the water, the bilge can
be drained by a thru-hull drain located in the
hull at the transom. The plug should be removed
whenever the boat is hauled out of the water and
installed just prior to launching. It is important
to check the drain plug regularly to make sure it
is tight.
CAUTION
A LOOSE DRAIN PLUG WILL ALLOW SEAWATER TO
ENTER THE BILGE AND COULD CAUSE THE BOAT TO
SINK. IT IS VERY IMPORTANT TO CHECK THE DRAIN PLUG
FREQUENTLY TO ENSURE IT IS PROPERLY TIGHTENED.
Notice:
See Electrical Systems for additional infor-
mation on bilge pump operation.
Notice:
Any oil spilled in the bilge must be thoroughly
removed and properly disposed of before op-
erating the bilge pump. The discharge of oil
from the bilge is illegal and subject to a fine.
CAUTION
THE FEDERAL WATER POLLUTION CONTROL ACT
PROHIBITS THE DISCHARGE OF OIL OR OILY WASTE
INTO OR UPON THE NAVIGABLE WATERS OF THE UNITED
STATES OR THE WATERS OF THE CONTIGUOUS ZONE IF
SUCH DISCHARGE CAUSES A FILM OR SHEEN UPON, OR
A DISCOLORATION OF THE SURFACE OF THE WATER, OR
CAUSES A SLUDGE OR EMULSION BENEATH THE SURFACE
OF THE WATER. VIOLATORS ARE SUBJECT TO A PENALTY
OF $10,000.
High Water Alarm & Emergency Pump Float Switch
Cabin & Bow Below Deck Compartment Bilge Pump Test Button
Hold For 5 Seconds Or Until Pump Activates
Automatic Float Switch Test Button
Push Button Down & Hold Until Pump & Alarm Activate