Monterey Boats 378SE, Руководство пользователя

Страница: 130 / 210

130
MONTEREY
BOATS
Interior Equipment
is completely closed and push the knob in. The
knob will stay in and the locking mechanism will
be activated. Make sure all knobs are pushed in
to activate the positive lock dead bolts whenever
the boat is underway.
Marine Head System
The 12 volt marine toilet is connected to the pres-
surized fresh water system which results in less
odor in the head compartment. It has an auto-
matic pumping device that fills and empties the
bowl. Once a button on the control is pressed, the
entire cycle is completely automatic. The system
uses very little water, approximately 2.27 quarts
(2.5 liters) per flush.
To use the toilet, make sure the Head System and
Water Pump circuit breakers are on. Then press
the “Add Water” button on toilet control panel to
add a preset amount of water to wet the bowl
which prevents organic residues dirtying the ce-
ramic sides. After using the toilet, pressing the
“Flush” button starts an automatic flushing cycle
that moves the waste to the holding tank and
leaves the bowl completely clean and dry in the
rest position.
The head contains an integrated, high-speed tur-
bine grinding pump that transfers waste to the
holding tank where it remains until it is pumped
out by a waste dumping station or the overboard
diaphragm discharge system.
The fluid level in the waste/holding tank is moni -
tored by a lighted LED symbol in the in the lower
starboard corner of the toilet control panel. The
symbol lighted green indicates the holding tank
is less than half full. The symbol lighted yellow
indicates the tank is at least half full. The symbol
lighted red indicates the tank is full and flushing
is not recommended. A lockout system built into
the control panel prevents the toilet from flushing
when the holding tank is full.
Refer to the toilet manufacturer owner’s manual
for more information on the operation of the ma-
rine head system.
Head System Holding Tank
The holding tank is located in the engine compart-
ment bilge. When the tank is full, the red LED
light on the toilet control panel will be lit, indicat-
ing that flushing is not recommended. The tank
must either be pumped out by an approved waste
dumping station through the waste deck fitting or
the optional overboard discharge pump.
Tecma Toilet Control Panel &
Overboard Macerator Discharge Switch
Waste Holding Tank
Holding Tank Vent Filter