MONTAGUE FB-108-R, Инструкция по эксплуатации

Страница: 12 / 33

SERVICE
FREEZER - LOW TEMP
This parameter should be set to “0.0” which
will reflect your temperature set point.
2. If an adjustment needs to be made to the set
temperature, use the “up arrow” button (#1)
or the “down arrow” button (#3) to adjust the
temperature. Press the “set” button (#2) to
save your adjustment. The display will again
show the temperature of the freezer base.
“FREEZER DIFFERENTIAL” MODE
1. Hold down the “set” button (#2) for at least
five seconds until a flashing “PS” is shown.
Press the “up arrow” button (#1) to reach the
flashing “rd” and press the “set” button (#2)
once. Make sure that this is set to “5.0” , this
is your refrigeration differential.
2. If an adjustment needs to be made to the set
temperature, use the “up arrow” button (#1)
or the “down arrow” button (#3) to adjust the
temperature. Press the “set” button (#2) to
save your adjustment. Doing this will send
you back to the menu showing a flashing
“rd” .
USING THE CAREL DIGITAL CONTROLLER
1. Up arrow button / Power button
2. Set button
3. Down arrow button
“OPERATIONAL” MODE
When the digital thermostat is running, the
temperature of the freezer base will be displayed
as shown in the photo.
ATTENTION: When you are ready to verify
the temperature set point and / or make
adjustments, please use the following steps:
“TEMPERATURE SET POINT” MODE
1. Hold down the “set” button (#2) for two
seconds until a flashing temperature is
7