14
RS232 Control
For RS232 control you will need to connect your PC to the matrix using the included RS232
cable. You will also need to use a third party RS232 control software, such as CommWatch
(not included). The following image shows the basic interface of CommWatch.
Use the following communications parameters:
Baud Rate: 9600
Data Bits:
8
Stop Bits:
1
Parity:
none
To allow for RS232 control, you must set the EDID DIP switches on the rear panel to 1111.
The matrix responds to the commands contained in the following table. Note that the
braces in the following commands (i.e., [ and ]) are not part of the commands and are used
only for clarity. The other punctuation marks ARE part of the commands.
