Monoprice 13860 Maker Select, Руководство пользователя

Страница: 39 / 50

39
Cool
The Cool section controls the operation of the cooling fan while printing.
Fan Full On At Height (mm) - This determines the vertical height at which the fan will
run at its maximum speed. This is especially useful for high thermal retaining filaments,
such as PLA.
Fan Speed Min (%) - This value sets the minimum fan speed to be used when the fan is
turned on. This is set as a percentage of the maximum speed.
Fan Speed Max (%) - This value sets the maximum fan speed to be used when the fan is
turned on. This is set as a percentage of the maximum speed.
Minimum Speed (mm/s) - The
Minimal Layer Time can cause the print to slow down so
much it oozes. This setting protects against this by ensuring that the print never slows
below this value.
Cool Head Lift - When enabled, this option lifts the printhead if the minimum speed is
activated because of a cooling slowdown.
Infill
The Infill section sets fine details controlling infill printing.
Solid Infill Top - When enabled, you will have a solid top layer. When disabled, the top
layer will be filled at the
Fill Percentage rate. Disabling this option is useful when
printing cups and vases.
Solid Infill Bottom - When enabled, you will have a solid bottom layer. When disabled,
the bottom layer will be filled at the
Fill Percentage rate. Disabling this option is useful
when printing buildings or caps.
Infill Overlap (%) - This value specifies the amount of overlap between the infill and the
walls. Some amount of overlap is necessary to ensure a firm connection between the
infill and walls.
Infill Prints After Perimeters - When enabled, the printer will print the infill after it prints
the perimeter, which can reduce the amount of infill that shows through the surface.
When disabled, the infill is printed before the perimeter lines.