Monogram ZV30S, Руководство по установке

Страница: 8 / 32

8
49-80152 Rev. 8
Installation Preparation
TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED)
Pencil and tape measure
Pliers
Pliers
Electric or battery operated drill
and 1/8", 3/8" bits
120V 60Hz. 15 or 20 Amp,
2-wire with ground. Properly
grounded branch circuit.
Electrical Cable
Key Hole Saw
Key Hole Saw
Hammer
Wire Cutter/Stripper
Wire cutter/
stripper
Step ladder
Ladder
Metal Snips
Metal Snips
Saber saw
or Sawzall
Saber Saw
Wire nuts
Wire Nuts
Phillips and flat
blade screwdrivers
Strain relief for
junction cover.
Strain Relief I
Spirit level
Level 2
Flashlight
Safety glasses
Safety Glasses
762Dia5
10" round metal
duct, length to
suit installation.
Duct tape
Duct Tape
REMOVE THE PACKAGING
■ Lift out the wooden crossmember, as well as the top
protective carton.
■ Lift out the four “L” shaped polystyrene protection
profiles.
■ Remove the protection moldings around the smaller
carton box.
■ Remove the small box housing the motor.
■ Lift the hood out of the box.
CAUTION
Lift the hood by grasping the outside
edges of the inlet opening of the hood. Do not lift the
hood by the exhaust opening divider—damage will
occur!
■ Remove the shipping screws holding the wood
mounting piece to the back side of the hood.
Set aside the wood mounting piece and screws for
later installation. Do not discard.
■ Remove the “V” shaped carton insert.
■ Remove the parts package from the “V” shaped
cardboard insert.
■ Remove the junction box cover and knockout.
■ Install the strain relief onto the back or top of the hood.
■ Remove all tape and packing material from the hood,
duct transition and motor.
1” = 2.5 cm; 1’ = 0.3 m