Monogram ZV30S, Руководство по установке

Страница: 7 / 32

49-80152 Rev. 8
7
Advance Planning
DUCT FITTINGS
Hoods Are Equipped
For 10" Round Duct
Use this chart to compute maximum
permissible lengths for duct runs to
outdoors.
NOTE: Do not exceed maximum
permissible equivalent lengths!
Maximum recommended duct
length for these hoods: 150 feet
Flexible ducting:
If flexible metal ducting is used,
all the equivalent feet values in
the table should be doubled. The
flexible metal duct should be straight
and smooth and extended as much
as possible.
DO NOT use flexible plastic ducting.
NOTE: Any home ventilation
system, such as a ventilation hood,
may interrupt the proper flow of
combustion air and exhaust required
by fireplaces, gas furnaces, gas
water heaters and other naturally
vented systems. To minimize the
chance of interruption of such
naturally vented systems, follow the
heating equipment manufacturer’s
guidelines and safety standards
such as those published by NFPA
and ASHRAE. When applicable,
install any makeup (replacement)
air system in accordance with local
building code requirements. Visit
GEAppliances.com for available
makeup air solutions.
Duct Piece Dimensions
Equivalent
Length*
Quantity
Used
Total
Equivalent
Length
10" round to 8" round 5 ft.
Round, straight 1 ft.
(per foot length)
3-1/4" x 10"
3-1/4" x 12" straight
1 ft.
(per foot length)
90° elbow 8" Dia. 17 ft.
10" Dia. 24 ft.
45° elbow 8" Dia. 10 ft.
10" Dia. 14 ft.
3-1/4” x 12”
3-1/4" x 10"
90° elbow
15 ft.
14 ft.
3-1/4" x 10"
3-1/4" x 12"
45° elbow
8 ft.
9 ft.
3-1/4" x 10"
3-1/4" x 12"
90° flat elbow
33 ft.
36 ft.
10" round transition
to 3-1/4" x 10" or
3-1/4" x 12"
9 ft.
3-1/4" x 10" or
3-1/4" x 12" to
10" round transition
6 ft.
10" round to 3-1/4" x 10"
3-1/4" x 12" transition
90° elbow
16 ft.
13 ft.
3-1/4" x 10"
3-1/4" x 12" to 10" round
transition 90° elbow
9 ft.
8 ft.
Round wall cap
with damper
8" Dia. 32 ft.
10" Dia. 41 ft.
3-1/4" x 10"
3-1/4" x 12" wall cap
with damper
24 ft.
26 ft.
Round roof cap 8" Dia. 44 ft.
10" Dia. 56 ft.
Total Duct Run
* Hoods are supplied with a 10” round transition. A locally supplied
transition is required for other sizes.
NOTE: Outlet on top of hood is 8-1/8” x 8”.
* Actual length of straight duct plus duct fitting equivalent. Equivalent
length of duct pieces are based on actual tests conducted by
GE Appliances Evaluation Engineering and reflect requirements for
good venting performance with any ventilation hood.
1” = 2.5 cm; 1’ = 0.3 m