Monark 915E, Инструкция по эксплуатации

Страница: 6 / 18

6
Fig. 5
Fig. 6
”R” höger
”L” vänster
3. Assembly of handlebar stem, bracket for
speed indicator and water bottle, and
brake lever attachment
Mount the pressure washer from the inside in the hole
on the front frame tube and fit the O-ring onto the
thrust washer from the outside.
Fit the bracket with speed indicator and water bottle
onto the handlebar stem tube together with the plastic
brake lever attachment. Then insert the handlebar stem
into the front tube on the bicycle and screw tight with
the locking knob. See fig.
The bracket for the speed indicator and water bottle
can be secured at a suitable height with the stop screw.
6. Assembly of pedals
The pedals are marked R (right) and L (left) at
the end of the pedal axle.
Assemble the toe clip on each pedal with the
accompanying washers, screws and nuts.
Thread the straps through the holes in the pedals
and through the holes in the toe clips.
Fit the pedal marked R on the bicycle’s right
side. The pedal axle is right-threaded and
should be screwed onto the crank in a
clockwise direction. Tighten well.
Fit the pedal marked L on the bicycle’s left side.
The pedal axle is left-threaded and should be
screwed onto the crank in an anti-clockwise
direction. Tighten well.
NB After approx. 5 hours cycling or as soon as
play in the axle attachment is observed, the
pedals should be tightened.
Tåstöd = Toe clip
Fotrem = Toe strap
Vevarm = Crank
4. Assembly of brake lever
Pass the brake lever rod through the hole in the
plastic attachment and then down into the hole in
the bicycle, see fig.
Screw in the knob clockwise about 10 turns. More
turns give load on the brake wheel, which can be
adjusted when cycling.