Monark 915E, Инструкция по эксплуатации

Страница: 10 / 18

Fig. 10
Justermutter
Tension device
Skarvbygel
Justerskruv
10
Fig. 9
Joint bracket
Screw
REPLACEMENT OF
BRAKE BELT
Remove the instrument cover assembled with
two screws. See fig. ?.
Remove left side cahin cover by disassembling
the connecting plate at the down side of the
covers. Remove the screw on the upper side.
Move the civer backwards and remove it from
the bike.
Adjust the tension device so that there is no
tension left in the brake belt. Loosen the screw
under the joint bracket. See fig. ??. Loosen the
screw fastening the belt in the watt scale. See
fig. ??.
Replace the brake belt and assemble the the
other parts in reverse order according to
above.Note how it is assembled. The new belt
must be assembled in the same way, see fig.
??.
Note: Too big a play in the bearing of the watt
scale may cause an unevan operation of the
load device. The nut for the watt scale bearing
bolt should thenbe tightened. See fig.??. Make
sure that it is not tightened too much as it may
then operate in a bad way.
CALIBRATION
Adjust the handwheel for the tension
screw so trhat there is no tension left
in the brake belt.
Fasten a 4 kg weight (our part no.
9000-211) at the joint bracket. See
fig. ??.
When correctly set the weight -4 kp
- will be read on the scale for watts
- 60 RPM. See fig. ??.
Should there be a deviation,
dismantle the chain guard. See fig.
??.
Adjust to the correct position by
means of the adjusting screw and
locking nut. See fig. ??.