Monaco DYNASTY 2006, Руководство пользователя

Страница: 185 / 384

DYNASTY 2006 EQUIPMENT — SECTION 5 • 185
Memory Control
To Program a Seat Position:
• Position seat as desired using the Power Base Control. Press the
SET
button once, then select the number
1
or
2 Memory
button. The selected
Memory
button will illuminate. When the seat position is memorized
the light will turn off.
To Move Seat to a Stored Position:
• Press the desired
Memory
button once. The light will illuminate until the seat reaches its programmed
position.
The driver seat can be programmed to move forward automatically when the slide-out switch is pressed.
To Program Seat Forward Position:
• Slide seat to full forward position.
• Press and hold the
Memory Set button.
• Press Memory buttons
1
&
2
and release
Set
button.
• Release Memory buttons. Lights on buttons will fl ash three times to signal program completed.
NOTE:
If the seat loses power the seat position will have to be re-programmed.
SWIVEL SEATS
Swivel Seat Operation:
• When swiveling a seat, lift up the swivel lever and
rotate to the desired position.
• The passenger seat swivels all the way around when
the slide-out is extended.
• When rotating the driver seat, put the steering wheel
in the upright position.
• Move the seat forward, then pull the swivel lever up
and rotate to the desired position.
WARNING:
Seats must be locked in the forward facing
position while the motorhome in transit.
NOTE:
After either seat is rotated 180º, it must be rotated back in the opposite direction. The 12
Volt wiring in the seat may disconnect if rotated 360º.
020243