Mold-Masters TempMaster XL-2 Series, Руководство пользователя

Страница: 7 / 39

XL-2 Manual Installation
Revision 1.1
Mold-Masters
®
Page 7
Installation
Where to use this equipment
Mold-Masters Hot Runner temperature controllers are designed
for use in the plastic injection moulding industry as temperature
controllers for hot runner systems as commonly used in mould
tools. The controllers must not be used in residential, commercial
or light-industrial environments. Furthermore, they must not be
used in an explosive atmosphere or where there is a possibility of
such an atmosphere developing.
They should be installed in a clean dry environment where the
ambient conditions do not exceed the following limits:
* Ambient temperature 0 to +50°C.
* Relative Humidity 90% (non-condensing)
When in use this equipment does not emit audible noise in excess
of 10dBA.
Controller — Tool Connections
The various connections to the system using the cables supplied
with the equipment are specified in Appendix A.
Controller Power Supplies
The control cabinet can be manufactured to accept a wide range
of supplies and sequence of phases. Refer to the serial plate in
the controller cabinet for confirmation of the supply requirements.
If the local supply is outside the specified range please contact our
Service department for advice.
Tel.: (1) 905-877-0185
(1) 800-450-2270
Fax: (1) 905-873-2818
WARNING