Mold-Masters TempMaster XL-2 Series, Руководство пользователя

Страница: 16 / 39

Setting up your controller XL-2 Manual
Page 16
Mold-Masters
®
Revision 1.1
Setting the Temperature Scale
Whether your display shows temperature in Fahrenheit or
Centigrade, changes in this parameter apply to both zones of the
controller card.
1. From the Temperature Display Screen, press and hold
button for at least 2 seconds until you get into Function Menu.
2. Use to scroll to “Prog”. Press to choose Program Menu.
3. Use to scroll to temperature unit parameter “C F”. You will
see the bottom display flashing.
4. Press to get access to change parameter setting. Bottom
display should stay.
5. Use or button to change setting.
6. Press to store the change. Bottom display should be
flashing again.
7. Press to get back to Temperature Display Screen.
Matching Sensor Types
There are two different types of probe sensors, J type and L type,
with different characteristics. The sensor type is normally
configured to a J-type before leaving the factory and should only
need to be altered in rare circumstances. Changes in this
parameter apply to both zones of the controller card.
1. From the Temperature Display Screen, press and hold for
at least 2 seconds until you get into Function Menu.
2. Use to scroll to “Prog”. Press to choose Program Menu.
3. Use to scroll to “J L”. You will see the bottom display
flashing.
4. Press to get access to change parameter setting. The
bottom display should stay.
5. Use or button to change to your desire setting.
6. Press to store the change. The bottom display should be
flashing again.
7. Press to get back to Temperature Display Screen.
Setting the Required Temperatures
1. From the Temperature Display Screen of the desired zone,
use or button to change the temperature setting.
2. Press to switch to the other zone and repeat the above step if
necessary.