5.14 Password Options
5.14.1 Password Enabled
If the user password option is set to [
Enabled
] then there are three levels of
control:
1. Open Level - includes various functions that need no password, such as
Start and Stop
2. User is a Level 1 password which gives low level access to:
a)
switch the tool on and off
b) change temperatures
c)
choose different tools
3. System is a Level 2 password which gives high level access to:
a) all user level functions
b) set the user password
c)
reconfigure the settings for a new tool
d) store and load new tool settings to or from the disk
5.14.2 Password Disabled
If the password option is set to [
Disabled
], then all those functions that would
normally need a User / Level 1 password become Open level and no longer
require any password to access.
Only those higher functions that require a System / Level 2 password retain
their password protection.
5.14.3 Password Active Times
After you key in a password, access is possible while you continue to input
data. Each keytouch resets the timer. After 20 seconds of inactivity, the
screen will time out.
NOTE
This is the same for both User / Level 1 and System / Level 2 passwords.
If the System password is active but the user visits a page requiring a Level
1 password or no password, then the System password will expire after 20
seconds. The user will still be able to access any page that requires a Level 1
password or no password.
5-21
SETUP
© 2021 Mold-Masters (2007) Limited. All Rights Reserved.
M1 Plus Controller User Manual
