Moen SW8001A, Руководство по установке

Страница: 5 / 16

墙面预钻膨胀螺栓底孔（可将铁架靠在墙上，
在墙面做孔位标记后进行钻孔。）
Pre-drill the bottom hole of expansion bolt on
the wall (You can put the iron frame against the wall,
drill holes after marking the holes on the wall. )
地面预钻膨胀螺栓底孔（可将铁架靠在墙上，
在地面做孔位标记后进行钻孔。地脚亦可取出
依实际要求调整方向装配后，取钻孔位置。）
Pre-drilled expansion bolt bottom holes on the ground
(you can put the iron frame against the ground.
The feet can also be taken out. After adjusting the
direction and assembling according to actual
requirements, take the drilling position. )
a
.
取出排污弯管刷上
PVC
胶；
b
. 将排污弯管卡接在管
夹上；
c
. 将整个产品提起，对准排污管插入，并再次补
刷胶水。调试墙脚、地脚安装距离并预紧。
a. Take out the sewage elbow and brush it with PVC
glue; b. Clamp the sewage elbow to the pipe clamp;
c. Lift the entire product, align it with the sewage pipe
and insert it, and apply glue again. Debug and
pre-tighten the installation distance of wall feet and feet.
用圈尺确认铁架上的
1
米高度标记与实测值一致后拧紧
锁紧墙脚组件螺母，锁紧地脚膨胀螺栓；完成铁架的安装。
Use a circle ruler to confirm that the 1 meter height
mark on the iron frame is consistent with the actual
measured value, and then tighten the wall foot
assembly nuts and lock the anchor expansion bolts;
complete the installation of the iron frame.
Ø10x75
0
1142
1000
560
墙面
Wall
墙面
Wall
墙面
Wall
墙面
Wall
0
1142
1000
地面
Ground
Debug and pre-tighten the
installation distance of the wall
foot
Tighten the wall foot assembly nut
Tighten the anchor expansion bolts
Adjust the installation height of
the foot and pre-tighten it
地面
Ground
地面
Ground
445
锁紧墙脚组件螺母
锁紧地脚膨胀螺栓
调试墙脚安装距离并预紧
调试地脚安装高度并预紧
一. 安装铁架
Install the Iron Frame