modec PY-68E-031, Инструкция по эксплуатации

Страница: 19 / 20

Instruction notice (EN)
19 NOT-PY68-EN-2020-v01
10. Problem solving
Petrol gas Portable Valve Actuator PY68
Symptom Probable causes Checks & solutions Repaired by
The actuator
won’t start
or stops during use
There is no petrol Add petrol User
The cursor button is on STOP Move the button to START
User
The cap of the starter spark plug is not
attached properly or is disconnected
Replace the cap
modec
Distributor
The starter spark plug is defective or
the spacing of the electrodes is
incorrect
See maintenance chapter
User
modec
Distributor
The motor is flooded Take out the spark plug, dry it with a cloth
User
modec
Distributor
The petrol filter is dirty, the air filter is
blocked, carburetor anomaly, starter
anomaly, valves seized etc.
Put the spark plug back in
modec
Distributor
The motor turns but the
actuator doesn’t work.
The clutch is worn out
Needs servicing by an expert
Distributeur
modec
The gear box is damaged
The motor heats
abnormally
The air filter is dirty Remove and clean the air filter
User
The starter spark plug is defective or
the spacing of the electrodes is
incorrect
Needs servicing by an expert
modec
Distributor
The motor’s cooling fins are dirty Clean the fins
User
Revolution counter (optional)
Symptom
Screen
status
Probable causes Checks Solutions Repaired by
The counter doesn’t
give a reading
Off
Timer elapsed / automatic
stop Activate the “ON”
button
User
Flat battery
Check the state of the
battery
Change the battery User
Screen is out of order
Check with a registered
modec
distributor
Change the screen
modec
Distributor
The counter is on but
doesn’t count
On and
not
moving
Poor connection between
the captor and the card Check the sensor connection Reconnect the sensor
User
modec
Distributor
Captor and/or the card is
out of order Check with a registered
modec
distributor
Change the electronic
card
modec
Distributor
Torque limiter (optional)
Symptom Probable causes Solutions Repaired by
The motor runs but the
output shaft doesn’t
The torque limiter is disconnected
Re-engage the torque limiter
Start the actuator smoothly
User
The torque limiter setting is too low
If possible, increase the maximum torque value User
Check the torque limiter status (is it damaged ?)
Change the torque limit range
modec
Distributor