Instruction notice (EN)
11
NOT-PY68-EN-2020-v01
3.
Place the “STOP-0 I START” button [2] in the START
4. Pull the starter grip gently until you feel resistance,
position. Press the two switch buttons and raise the
then pull briskly and return the starter grip gently.
cursor into the START position.
5.
When the motor has started, move back the choke lever [6] in the down position.
PRECAUTION :
•
Don’t pull the starter grip to its full extent.
•
Do not allow the starter grip to snap back against the actuator. Return it gently to prevent damage to the starter.
NOTE : Always pull the starter grip vigorously. If you don’t, the spark plug won’t produce the sparks needed to start the
motor. Don’t place a foot or knee on the transmissions tube to stabilise the machine – you could twist it and make the
machine unusable.
HOT START
The actuator is considered as « hot » if it has ran over more than 5 minutes in the past 10 minutes. The procedure for starting
from hot is identical to that of starting from cold except that there is no need to use the choke that should remain in the down
position [6].
NOTE: In case of difficulty starting the motor from hot, use the following procedure:
1.
Turn the actuator switch « STOP-0
I
START » to the “STOP-0” position.
2.
Move the choke lever down to the “open” position.
3.
Hold the throttle lever in the max speed position.
4.
Pull the starter grip 3 to 5 times.
5.
Start the actuator following the procedure described above.
STOPPING THE ACTUATOR
1. To stop the engine, simply push the
actuator switch « STOP-0
I
START » to the “STOP-0” position
2. This is also the way to stop the actuator in case of emergency.
Please note that the actuator can carry on turning by inertia after stopping the motor.
[2]
[5]
