Instruction notice (EN)
10
NOT-PY68-EN-2020-v01
Petrol tank capacity :
0,63 L
Recommended fuel
Super unleaded.
Octane rating 91 minim.
5. Starting up the Portable Valve Actuator
a.
Filling the fuel tank
Pressure can increase in containers holding petrol, due to the ambient temperature. Open the petrol cap carefully
to avoid any projection. Leave the fuel in a cool place, for short periods and never leave it in the sun.
PRECAUTION
Clean the fuel tank cap and its surrounds to
prevent any foreign bodies entering the tank.
Fill the fuel tank using an appropriate-sized
funnel or from a can with a special pouring
head.
For greater convenience, place the machine in
the operating position.
Make sure the apparatus is stable while carrying
out this procedure so it doesn’t topple over.
STORING FUEL
PETROL CONTAINING ALCOHOL
FILLING THE OIL TANK
CHECKING THE OIL LEVEL
b.
Before starting up
Check the protection casings are in place, correctly tightened and are not showing any defects (cracks).
Check that any accessories are attached correctly and firmly, check the condition of the handles and switches as well
as the petrol and oil tank caps.
Move the machine away from where the fuel was added.
Place the actuator flat on the ground close the device that it will actuate.
Make sure that the spark plug hood is in place.
GENERAL PRECAUTION :
Make sure the “STOP-0 I START” button is in the stop position (0) and never start the actuator directly coupled to a
handwheel or valve.
If this precaution is not taken, the actuator risks being set in motion when the motor starts (despite the clutch) and
could cause bodily harm.
The petrol gas actuator PY68 can run in any position but must be started up horizontaly so that lubrication is correct.
COLD START
The actuator is considered “cold” if the motor has not been turned over prior to starting.
NOTE: If the ambient temperature is quite hot (in summer), it may be that the motor starts better without a choke.
START UP AS FOLLOWS:
1.
Move the choke lever (3) in the up position (closed).
2.
Press several times on the priming bulb [4],
located under the carburetor, to draw in the petrol.
For these points, consult the user manual of the
Honda GX35 motor
