Mobotix T24S, Руководство по эксплуатации и установке

Страница: 89 / 100

89
/98
Final Notes
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
4.3.4 Starting The Camera With Factory Defaults
Under certain circumstances, you may have to reset the camera to its factory settings.
This could be the case, for example, if the IP address has been lost or the camera does
not respond to the last known IP address.
1. Disconnect the camera's power supply (disconnect the cable).
2. Reconnect the power supply of the camera.
3. Wait until the buttons light up.
4. Press the
upper button (light)
on the camera within four seconds.
5. After about two seconds, the camera will play a sound ("boing"). The camera is
now configured as a DHCP client again and is additionally accessible using its
factory IP address (see label on the camera housing).
Notes
If you use the
upper key
on the camera to load the factory configuration, this configu-
ration is not automatically saved in the camera's flash memory. When the camera
is next rebooted without using the
upper key
, the last stored network configuration
will be used. To permanently store the new network configuration in the camera's
flash memory, open
Admin Menu > Store
.
Caution
In contrast to resetting the camera using
Admin Menu > Reset configuration to
factory defaults
, the user information will not be reset if the camera is booted using
the factory configuration.
The T24S with only one
button (light) features
a rocker switch, of
which the upper area
must be pressed
Press top button (light)