91
/148
Network And Power Connection, Additional Cables
© MOBOTIX AG • Security Vision Systems • Made in Germany
www.mobotix.com • [email protected]
2.5.2 Network Cabling For S14 With Patch Cables
1.
Remove housing cover and cable
plugs
: Loosen the Allen screw on
the housing cover of the S14 and
remove it. Push the cable plug
in the camera out of the hous-
ing from the inside to the outside
(red arrow).
2.
Attach the cable ties
: Feed one
of the cable ties supplied through
both slots in the circuit board
underneath the LSA cutting clamp.
3.
Prepare the installation cable
:
Cut the installation cable to
length, feed through the white
single wire plug (5-7 mm/0.2 to
0.28 in), remove 35 mm/1.38 in of
insulation and separate into indi-
vidual twisted wire pairs including
15 mm/0.6 in sheathing. Wind the
shield mesh around the sheath to
a width of 10 mm/0.4 in so that it
can be fixed on the contact surface
later using the cable tie.
4.
Secure the cable
: Push the
plug out and insert the installa-
tion cable with single wire plug
(5-7 mm/0.2 to 0.28 in) into the
opening intended for the instal-
lation cable. The rubber sleeve
must sit tightly on the installation
cable to prevent the penetration
of moisture. Tighten the cable tie
around the shield mesh to ensure
less tension.
~15 mm
~35 mm
~20 mm
~10 mm
Shield mesh
Cable
sheath
Wire shield
Ensure that the instal-
lation cable is fed right
into the housing when
the camera is in the right
position so that the cable
plug provides optimal
sealing for the housing
