Add-on to an MA 1000 System Installation
MA 850 Installation and Configuration Guide
16
6. Connect the network connection to the MA 850 rear panel network port.
NOTE 1:
Each unit is pre-assigned an IP address. The address can be modified anytime through a
remote connection according to the procedure described in section
4.2.1).
NOTE 2:
It is recommended to record the location of the units according to the MAC addresses on the
sticker at the rear of the units near the Ethernet port.
3.4
Add-on to an MA 1000 System Installation
In this type of installation, the MA 850 and MA 1000 RHU are assembled together with a
bracket
between them.
NOTE:
It is recommended to mount the MA 850 to the wall, and the MA 1000 on top of the MA
850 (with a bracket between them). However, if a previous MA 1000 RHU is present, you may
install the MA850 on top of the existing MA 1000 RHU (with a bracket between them.)
To assemble an RHU 1000 onto an MA 850
1. Assemble the supplied bracket to the top of the MA 850, where the notched side of the
bracket is towards the rear of the unit. Secure the bracket to the MA 850 unit using the four
supplied screws.
Figure
3-1. MA 850 and Bracket Assembly
2. Mount the MA 850 and bracket assembly to the wall. When mounting, consider the
following:
•
The type of screws used to mount the unit must suit the type of wall construction
(cement, bricks, etc.) so that the mount is secure.
•
The position of the APs and required cable connections.
3. Mount the MA 1000 RHU to the bracket using the four provided screws.
4. For antenna sensing support (RHU 1000 version 3.1 and higher), connect between the
Control
connectors at the rear of both units using cable
705102101.
Two screws
Two screws