Mobatime DT.100.1C.1T, Инструкция по эксплуатации, Страница: 30 / 40

© MOBATIME 30 / 40 800845.01
9 Update firmware
9.1 Update firmware using RS232

Switch-off the clock.

Install and run the Flash Magic software.

Open the configuration file „dc3prog.fms“ over the File -> Open Settings
menu

Set used COM Port and open file firmware „dc3.hex“using the Browse key

Connect the programmer to serial COM Port of computer (the USB-RS232
converter can be used) and connect the power supply to the jack on the
programmer.

Install the jumper ISPE (JP9).

Connect the programmer to connector PROG (JP8), LED POWER placed on
the clock lights up.

Click the Start button to run programming, after completion a “Finished”
message will be displayed in the bottom part of the widow

Disconnect the programmer and remove the ISPE jumper.

Firmware version can be checked in the last item of clock menu.
9.2 Update firmware over Ethernet at NTP version

Create a folder on the computer disk and copy "tftpd32.ini", "tftpd32.chm" and
"tftpd32.exe" in it. Copy the file of new firmware "dc3app.bin" as well.

Run "tftpd32.exe" let only TFTP Server in the window Settings -> Global
Settings set, don’t change other settings.

By the Browse key open choice of active directory and find the one which
contains the given firmware

Connect to the clock by the windows command telnet <ip clock address>
example: telnet 192.168.0.190

The page of telnet requesting will appear, after the password entered
identification of current software version and clock MAC address displays.

Enter the command fu in telnet window for start the automatic update clock
firmware from the "dc3app.bin" file.

Information about sending file and its progress displays in the tftpd32
programme window after the command entering. Connection to telnet is
ended automatically.

Wait about 1 minute after end of sending. Connect the telnet to clock again.

After entering the password, check if the firmware version is correct, if it isn’t,
it is necessary to repeat the whole procedure.

Close the telnet window and end the program tftpd32 with the command exit .