Mobatime DT.100.1C.1T, Инструкция по эксплуатации, Страница: 10 / 40

© MOBATIME 10 / 40 800845.01
2.6 Function of the plug connectors

LINES, DC/DCF OUT – JP1 time signal inputs: The DCF/GPS receiver,
polarized impulse line, MOBALine, MOBATIME
serial code, IRIG-B,
power supply output: DC OUT 12–40 VDC
or passive DCF current loop output

TEMP – JP2 connection of the temperature sensor(s)

CTRL – JP3 connection of the keyboard

RS232 – JP4 (optional) connection of the RS232 serial line

RS485 – JP5 (optional) connection of the RS485 serial line

100 – 240VAC – JP6 powering 100 - 240 VAC voltage

LAN - JP7 (optional) RJ45 10BaseT/100TX (IEEE 802.3)
auto negotiation

PROG – JP8 clock firmware programming

RELAY – JP27(optional) switching contact connection
2.7 Setting elements

Line type jumper – JP11 for the setting of the slave line type
IRIG / AFNOR
DCF
MOBALine
(Un)polarized impulse line
MOBATIME serial code

PB1, PB2 control pushbuttons

RESET the RESET button

TRE jumper – JP10 (optional) RS485 terminating resistor enable

BATT jumper – JP12 backup battery connection

ISPE jumper – JP9 invoking the firmware programming mode

DCF LED indication of receiving the DCF signal

STATE LED state indication

POWER LED power indication

jumper DC Out / DCF Out – JP17 Output signal setting on pins 3, 4
of the JP1 connector
pin3 = DC Out + (12-40V)
DC Out
pin4 = DC Out -
pin3 = (+)
passive DCF Out
pin4 = (-)