Mobatime DT.100.1C.1T, Инструкция по эксплуатации

Страница: 25 / 40

© MOBATIME 25 / 40 800845.01
Enter temperature correction value in format xx.x , the range is from -9.9 to +9.9
degrees.
Push the >> button to move to the communication mode setting.
The display shows L : x .
When a 0 value is set, the display works as a master on the RS-485 bus, value 1
means the display works only as a listener on the bus. On the single RS485 bus
just one display device must be master and the others must be listeners.
By pushing OK , the entered values are stored and the display returns to the
menu item P13 (or P14 or P15 respectively). By pushing ESC return without
storing.
6.9 Settings for the TP LAN temperature sensors
Set the value 3 in the P13 (or P14 or P15 respectively) menu item, and then by
pushing the SET enter the submenu for setting the IP address, measured
temperature correction and timing value. The item to be set is blinking.
Set four octets of the IP address of NTP server step
by step. Switch to another octet/digit by pushing the
<< and >> buttons. Octets are marked by letters A , b ,
C and d .
After entering the last octet push the >> button to move to the temperature
correction setting.
The display shows cxx.x .
Enter temperature correction value in format xx.x , the range is from -9.9 to +9.9
degrees.
Push the >> button to move to the timing value setting.
The display shows n :xx .
Set the value xx according to predicted number of display units, which should
communicate with the actual temperature sensor. Then the apropriate timing for
the communication with the sensor is applied.
By pushing OK , the entered values are stored and the display returns to the
menu
6.10 Manual setting of the IP address of the clock
Choose the item P18 in the main menu and push the SET button to enter the
submenu for setting the IP address. The item to be set is blinking.
The display shows the following:
Enter four octets of the IP address step
by step. Switch to another octet by
pushing the
<< and >> buttons. Octets
are marked by letters A , b , C and d .
By pushing OK, the entered values are stored and the clock returns to the menu
item P18. By pushing ESC the clock returns to P18 without storing.
6.11 Manual setting of the subnet mask
Choose the item P19 in the main menu and push the SET button to enter the
submenu for setting the subnet mask. The item to be set is blinking.