2. Min Down:
Minimum signal applied to move hydraulics in downward
direction. This signal is applied when the signal from the connected sensor is just
on
o
the ‘ON TARGET’ (green) band. If set to high, the bucket or blade will
overshoot the target going down. If set too low, the blade or bucket may not
move up at all when only small downward adjustment is required.
3. MAX UP:
Maximum signal t
applied to move hydraulics in upward
hat is
direction. This signal is applied when the signal from the connected sensor is
below the ‘ON TARGET’ (green) band by an amount that is greater than or equal
to the proportional range of the sensor. If set to high, the bucket or blade may
o
move too fast and overshoots the target. If set too low, movement may be too
slow.
4. MAX Down:
Maximum signal t
applied to move hydraulics in
hat is
downward direction.
This signal is applied when the signal from the connected
sensor is below the ‘ON TARGET’ (green) band by an amount that is greater
than or equal to the proportional range of the sensor. If set to high, the bucket
o
or blade may move too fast and overshoots the target. If set too low, movement
may be too slow.
5. Direction:
ormal or everse direction for hydraulics movement. When
N
R
R
up
everse direction is selected, the
will activate Down hydraulics when
DUO2
control is applied and will activate UP hydraulics when own signal is applied.
d
1. Min up:
Minimum signal
applied to
that is
move
in upward direction
the blade or bucket
.
This signal is applied when the signal from the
connected sensor is just
the ‘ON TARGET’
on
(green) band. If set to high, the bucket or blade
o
will overshoots the target going up. If set too low,
the blade or bucket may not move up at all when
only small upward adjustment is required.
GENERAL SETTINGS - VO HYDRAULICS
3.7.2.1
(VO) General Settings
Min Down = 10.0%
Min Up = 10.0%
Max Up = 100.0%
Max Down = 100.0%
Exit
Direction = Normal
figure 15
