6.3 GN S JOB TYPE SELECTION & SETUP
S
Press
key to bring up the job selection menu. Select the job type and
[ENTER]
follow nstructions to setup the job direction.
i
Flat Job?
Slope Job
Dual Slope Job
Exit
Job Type [Slope]
Job Target Settings
Exit
To set the job direction enter the position of the two reference points A & B using
the following instructions.
Note: For the single & dual slopes provide a minimum distance of 10m between
reference points A & B to define accurately the orientation of slope targets.
Set up a new job
Please drive to
Ref Point A
then press Enter
Set up a new job
Setting
Ref Point A
Continue with these same steps to set up reference point B.
Set up a new job
Please drive to
Ref Point B
then press Enter
Set up a new job
Setting
Ref Point B
Job has been Setup
Confirm that the job setup has been completed
successfully.
For Single Slope and Dual Slope go to the job
target settings and us
configure
e [AUX2] key to
the required slope settings.
Job Type [Slope]
Job Target Settings
Exit
GPS Single Slope
Slope 1 = +0.000%
Exit
figure 56
figure 57
figure 55
