13
IDL280-LM Series
Long Travel Industrial Linear Stages
⑤
Unscrew and remove 8 mounting rods of the lifting rings and the
locking plate.
5.3
Mounting Conditions
IDL280-LM stages feature an eight-point mounting pattern which is ideal for
non-flat surfaces. However it is recommended for all IDL280-LM stages that
the following mounting conditions be adhered to for best performance and
securiry.
5.4
Air Blowing
When used in dusty environment (dust, debris…), the stage can be
protected by connecting an air source to the air tube plug (see sections
4.8 & 8.0 of this manual). This will prevent pollution from coming in by
slightly increasing stage internal pressure. Such air injection can also be
used to improve motor heat dissipation and limit temperature increase.
Here are the required characteristics for the air source:
•
Pressure: 6.0 bars
•
Particle size: 5 µm
•
Particle density: 5 mg/m
3
•
Dew point: -20 °C
•
Gas Oil ratio: 1 mg/m
3
Installation Considerations
<400 mm Travel
<800 mm Travel
Mounting surface flatness
10 µm
15 µm
Payload surface flatness
20 µm
20 µm
Mounting Screw torque
M8: 16.0 Nm
M6: 7.0 Nm
M5: 4.1 Nm
M4: 2.1 Nm
A1045F0 - EDH0362En1050 — 02/20
